ANCS Acupuncture Needle Wire Hwato Machine Wire With Needle Clip Still alligator/crocodile

Using ANCS acupuncture machine wires (alligator clips) with a Hwato stimulator allows you to send gentle electrical pulses through inserted needles. You simply attach the wire clip to the handle of the sterile needle. Here is the step-by-step guide to using them safely:1. Preparation Turn Off the Machine: Ensure the Hwato device is completely switched off. Check the Battery / Power: Insert a 9V battery or plug in the power adapter. Insert Needles: Properly and safely insert your acupuncture needles into the patient's acupoints.2. Connect the Wires Plug into Machine: Insert the pin-end of the lead wire into one of the channel output ports on the front of the Hwato machine (e.g., Channel 1).Attach the Clips: Gently open the alligator clip at the other end of the wire. lip the Needle: Pinch the clip and carefully clamp it onto the metal handle of the inserted acupuncture needle. Important Safety Note: Make sure the clip does not touch the patient's skin or push the needle deeper.3. Start Therapy Turn On: Turn the machine on and set the desired output channel. Set Intensity: Start with the intensity dial completely at zero to avoid delivering an electrical shock. Slowly increase the dial until the patient feels a comfortable, mild tingling sensation. Set Frequency/Wave: Adjust the frequency (Hz) and wave type (e.g., continuous, intermittent, or dense-disperse) based on the treatment goals (e.g., low for relaxation, high for muscle stimulation).4. Duration and Removal Session Time: Typical electroacupuncture sessions last between 15 to 30 minutes. Safe Removal: Always turn the intensity dial back down to zero before removing the clips or taking out the needles. Disconnect the alligator clips first, then safely remove the needles